Several things happened in November that has inspired me to finally document the story about a building whose history I had previously researched but never shared. It’s the story of a rear-courtyard-style building two blocks from the Garfield Park Conservatory that had 18 dwelling units, was demolished in the 1990s due to unpaid water bills, and rezoned – along with many other buildings nearby and across the city – to allow the next owner to build only seven dwelling units.
Those three things, for the curious: A question was posed to the speaker at a recent real estate group luncheon about the prevalence of downzoning in Chicago and the impact that might have on limiting some redevelopment of vacant lots; the city’s launch of ChiBlockBuilder, a program that replaces and expands upon the former $1 Large Lots program; and a meetup I attended with other urban planners to discuss, among other topics, zoning, transit, and cannabis dispensaries.
I make a few contentions in this blog post about zoning in Chicago. Among them:
- Downzoning is a municipal practice that reduces how densely a property can be developed; in this context, the number of dwelling units allowed.
- The zoning text and maps have progressively downzoned the city between the first zoning code and today’s zoning code; this blog post reviews the zoning text changes using a case study of a single building.
- The zoning text and map at the time allowed an 18-unit building to be built on a particular property in East Garfield Park but the current zoning text and map allows only a seven-unit building to be built.
Introducing the vacant lot at 3454 W Fulton Blvd
There is a vacant lot owned by the City of Chicago at the northeast corner of Fulton Boulevard and St. Louis Avenue in East Garfield Park, in view of the renowned Garfield Park Conservatory. The lot has an area of 7,500 square feet.
The property’s PIN is 16-11-404-025-0000 (open its Address Snapshot on Chicago Cityscape).
For what it’s worth, the southeast corner lot had 15 units, the southwest corner lot had 18 units. Then there’s the northwest corner lot that had a rear-courtyard-style building with interior corridors with 45 units (that’s 250 percent more units on a lot that’s 150 percent larger). (See Sanborn map volume 11, sheet 83, to visualize the corners on the west side of St. Louis Ave.)
The timeline of construction to demolition to city ownership to resale
The flats were built between 1922 and 1949, according to Sanborn maps (link to 1922 map, volume 11, sheet 83, hosted by the Library of Congress, which shows a vacant lot, while the 1949 version above shows the building).
In February 1992, the City of Chicago’s water department filed a statutory lien on the property to claim and to notify the owner that there was unpaid water service balance of $2,593.89.
If the building was dilapidated and had been cited, I did not find evidence in the documents available at online Cook County and City of Chicago sources. There is evidence, however, that the property was sold in 1988 a five-year delinquent tax sale.
The lot had six adjoining three-flats for a total of 18 units until its demolition, by the City of Chicago, on February 12, 1992 (read the lien the city filed against Exchange National Bank, in the amount of $14,754, to cover the cost of demolition).
Seven years later, on March 1999, the City of Chicago acquired the lot after succeeding in its lawsuit against Exchange National Bank in the Cook County Circuit Court’s Chancery Division (case number 95 CH 3958).
I’m going to repeat this part: Available evidence shows that the City of Chicago demolished the building due to unpaid water bills. I believe that political and planning circumstances – and policies – have changed such that if the situation were repeated in 2022 the building would not be demolished. For example, there is a coalition program called the Troubled Buildings Initiative that the city helped found in the mid-2000s to place buildings in this and similar situations into “receivership”, to ensure that the building does not get demolished and can actually be stabilized and improved (renovated). This is a better way of handling the problem!
Fast forward twenty-three years from the acquisition in 1999 to now. The lot is for sale to eligible neighbors – for the second time this decade – for use as a landscaped space (side yard, garden, plaza) or redeveloped (anything allowed by zoning, but you may need assistance learning to decode the zoning code).
The lot was first for sale in the Large Lots program during one or more of the tranches promoted between 2015 and 2018. The lot is now for sale since the ChiBlockBuilder program launched on November 17, 2022.
The rules are different between the former Large Lots program and ChiBlockBuilder. In the past, anyone who owned property on the same block or across the alley could apply to acquire the lot. All lots were sold for $1.
Now, through ChiBlockBuilder, interested buyers who want a low-cost acquisition must own and live in a property adjacent to the lot. This lot has only one eligible neighbor; I don’t know if the owner lives there. If they do, they can acquire the property for 10 percent of its market value.
That’s another difference between Large Lots and ChiBlockBuilder: All properties for sale (which is a subset of all properties that will eventually be for sale) have already had their market value appraised.
The market value for 3454 W Fulton Blvd is $29,953 or $2,995 for eligible applicants. There’s one other group of potential buyers that can obtain lots for 10 percent of market value and that’s non-profit organizations who have a proposal for a landscaped-based project.
What does zoning allow?
Successful neighboring owner-occupant buyers are able to do anything with the vacant lot that zoning allows. Although, without an expertise in reading the Chicago zoning code or a tool like Chicago Cityscape, it will be hard to know what that is.
My real estate information company, Chicago Cityscape, automatically generates a “Zoning Assessment” for every parcel in Chicago.
At 3454 W Fulton Blvd, the Zoning Assessment estimates that, currently, seven dwelling units are permissible, 11 fewer than what were extant there back in 1992.
Downzoning takes effect: Zoning codes of 1923, 1944, 1957, and 2004
Downzoning is a process – through either a change in the map (the zoning district assigned to a property) or a change in the text – that reduces the number of dwelling units permissible on a given lot.
In the 1923 zoning code, Chicago’s first, the allowable density of building on this lot was controlled by the “2nd Volume District” which established very simple rules: a ground coverage limit of 75 percent, and a height limit of 66 feet. The building height could be higher with an upper floor setback.
Multiplying the lot size of 7,500 s.f. by 0.75 equals a maximum building footprint of 5,625 s.f. Multiply that by six floors and there’s a maximum floor area of approximately 33,750 s.f. This created an FAR of 4.5.
In the 1944 zoning code, the allowable density of building on this lot was still controlled by the “2nd Volume District” but the maximum density had been reduced: a ground coverage limit of 45 percent, and a height limit of 45 feet (the current zoning code applies a height limit of 38 feet on the lot in question, while ground coverage is dictated by FAR and setbacks standards that the 1944 zoning code didn’t have).
Multiplying the lot size of 7,500 s.f. by 0.45 equals a maximum building footprint of 3,375 s.f. Multiply that by four floors and there’s a maximum floor area of approximately 13,500 s.f. This created an FAR of 1.8.
Yet neither the 1923 nor the 1944 zoning codes had a limit on the number of dwelling units. The number of dwelling units was thus limited by whatever building code standards there were and the unit sizes the builder wanted to market.
The 1957 zoning code introduced a more stratified Use + Density schedule of districts more similar to the current zoning code than the two prior codes. The map was drawn to place 3454 W Fulton Blvd into an “R4” district.
In 1957, the R4 zoning district applied a new density rule that there can only be one dwelling unit per 900 s.f. of lot area. This differs from the prior two codes which did not have a standard establishing a maximum number of units.
Since the lot has an area of 7,500 s.f., that equals eight dwelling units allowed.
The 1957 zoning code also introduced a floor area ratio (FAR) of 1.2 to control building size, and front, side, and rear yard setbacks that controlled lot coverage. Remember that this lot had an effective allowable FAR of 4.5 in 1923 and 1.8 in 1944.
I think it needs to be pointed out that the most dense residential-only zoning district in the 1957 zoning code – R8 – allowed more than twice the number of units on a given lot than the most dense residential-only zoning district in the current zoning code – RM-6.5. It was a matter of requiring 135 s.f. of lot area per dwelling unit prior to 2004 and 300 s.f. of lot area per dwelling unit since 2004, respectively.
In practical terms, if the lot was zoned R8 in 1957-2003 then 55 units would be allowed; if it was zoned RM-6.5 in 2004-2022 then 25 units would be allowed.
In the current zoning code, adopted in 2004, the lot’s “R4” zoning district designation was converted to “RT-4”. The code was updated to reduce the density rule from requiring 900 s.f. of lot area per dwelling unit to requiring 1,000 s.f. of lot area per dwelling unit. Since the lot has an area of 7,500 s.f., that means seven dwelling units are allowed here (also, the zoning code says the number must be rounded down in instances where there is a maximum standard). That’s a difference of one unit, so hardly an indictment of the downzoning of this lot that occurred between 1957 and 2004.
The FAR stayed the same between the 1957 and 2004 zoning codes, at 1.2 (far below 4.5 in 1923 and less than 1.8 in 1944).
Allowed zoning summary
I contend that there was a severe decline in the number of dwelling units allowed between Chicago’s first and fourth (current) zoning codes, manifested through a reduction in reduced height limits and lot coverage between 1923 and 1944 and the introduction of the maximum number of units standard (called “minimum lot area per unit”) in 1957. The zoning code in 2004, as it pertains to this lot, looks very much like the zoning code in 1957.
- Another big change between the 1957 and 2004 zoning codes was the amount of parking required: in the equivalent zoning districts, the 1957 zoning code required 0.75 spaces per dwelling unit while the 2004 zoning code requires 1 space per dwelling unit, which is still the case as proximity to transit has no bearing on RT-4 zoning districts.
- The 1923 had a cap on the number of garage parking spaces of one space per dwelling unit. This cap went away at some point, and has been reinstated in a limited basis in the “Connected Communities” ordinance adopted in 2022.
- The 1923 zoning code allows more “auxiliary” uses in “apartment districts”, such as the one governing the vacant lot in question, compared to the current RT-4 zoning district, including: a boarding or lodging house, and an apartment hotel with a restaurant or dining room that is entered from within the lobby. (I don’t think apartment hotels exist anymore in Chicago.)
- In 2022, the Chicago City Council adopted a zoning code amendment called “Connected Communities” which would allow the next owner of this vacant lot to build housing without any car parking – like it was in the 1920s – if they were to also obtain an upzone (that is, a zoning map amendment to a higher-density zoning district) to RM-5 or higher. This is because the lot is near enough to an eligible transit service.
P.S. The other type of downzoning (or upzoning) is to change the map. This means to reassign certain parcels to a different zoning district. Chicago city council members do this constantly, often for unknown or unexplained reasons. When it is explained, it’s often to ensure that a property owner must proposed a project to the alderperson and then obtain their permission to (usually) upzone.
When the zoning is changed one parcel at a time, or several parcels for a single property owner, this process of downzoning – or upzoning – gets an additional name: spot zoning. This is generally bad urban planning and development policy and has been part of political corruption. Chicago used to have a department policy that rezonings (changes to the zoning map) had to cover at least 10,000 s.f. of contiguous parcel area at a time (just a little bit larger than three standard size lots).
Several examples of alderperson-initiated downzoning in the 2010s include (from memory):
- Former alderperson, and chairperson of the City Council’s zoning committee, Danny Solis, downzoned a large residential property in Pilsen to “M” (industrial); the property owner, PMG, sued Solis and the City of Chicago. The settlement was that the city would buy the land from PMG at market rate. This is now the 18th & Peoria development site, and the city is conducting public meetings to determine how to develop it.
- Alderperson Roberto Maldonado submitted dozens of downzoning ordinances to City Council in ~2020, to change vacant lots in Humboldt Park and Logan Square from RT-4 (which would allow a three-flat) to RS-3 (which would allow a single-detached house, and in rare locations, a two-flat). The planning department staff had to limit his submissions to a few per month because they could not handle all of his ordinances amongst their other work processing real zoning change applications.
- Alderperson Carlos Ramirez-Rosa downzoned a commercial district along Milwaukee Avenue north of Diversey Avenue to allow a lower density and lower height. Any developer that proposed more than allowed has to go through the 35th Ward Community Zoning Process (I have not personally experienced this process but I appreciate that it’s well-documented and seems to be applied consistently). The scope of the downzoning was reduced after some pushback.